Supco PCS220 - Battery Installation; Over Range Indicator; Parts Included

8
Battery Installation
1. Remove the battery cover from the rear of the control box by compressing tab at the base
of the battery cover.
2. If necessary, remove old set of batteries.
3. Insert 5 ‘AA’. Replace battery cover by aligning
Important:
TO PREVENT DAMAGE TO THE PCS220, CAREFULLY OBSERVE BATTERY POLARITY AS
MARKED INSIDE THE BATTERY COMPARTMENT. DO NOT LEAVE DEAD BATTERIES INSIDE
THE CONTROL BOX. REMOVE BATTERIES IF THE PCS220 IS NOT TO BE USED FOR AN
EXTENDED PERIOD OF TIME.
Over Range Indicator
If the weight applied to the weighing platform exceeds the maximum capacity of the PCS220
(200 lbs), ‘OL’ will be displayed in the middle of the display. To prevent damage to the
PCS220, immediately remove the weight from the platform.
Parts Included
1. 1 set refrigerant charging scale
2. 5 PCS 1.5V “AA” alkaline batteries
3. 1 PCS charging hose
4. 1 user’s guide manual
5. 1 PCS molded case
9
PCS220 Manual.indd 10 10/27/2011 10:08:11 AM
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com