Super Feeder CSF-3 - Step 9: Timer Programming; Mounting to Wood Stand; Mounting to Pole

Super Feeder Installation, cont.
Fig. 9
Page 5
timer or home automation system to reset the feeder
for the next feed cycle.
Note: When the rubber plug is closed, push the right
side labeled “push” for additional feed cycles while the
feeder is powered (no need to open rubber plug). (See
Fig. 9)
STEP 9
Aer installation is complete, see timer programming
sheet for your specic purchased timer. Any other timer
of your own can be used and programmed similarly.
Basically, the number of on-o cycles your timer has is
the number of feed cycles available.
With wood stand or other mounts
For mounting the Super Feeder to a wood stand, use 2
large 1/2" head screws on each side (see Fig. 10).
For mounting to a pole, bend the mounting ears on
the “L” bracket out (see Fig. 11 and 12). ese ears
accommodate 3/4" to 2" diameter pipes. You will need
to supply you own hardware screws to mount the metal
retaining strap.
Fig. 10
Fig. 11
Fig. 12
Cable ties
Mounting Ears