Step 1: Attach 4 rubber feet in designated areas.
Step 2: Use the 4 large head screws to attach the tower
to the base from the bottom.
Step 3: Attach feeder, bracket and strap assembly to
tower with 8 Small black head screws (4 on each side).
Assembly Parts
4 - Large Head Screws
4 - Rubber Feet
1 - Tower
1 - Base
Recommended placement of feeder is on hard surface
backed up to wall or next to walls in a corner.
Available separately or with combos
A: Gently squeeze the top
portion of the feeder and
tower so that the feeder will
raise slightly.
B: Slide the
top bowl tabs
between and
under the
bracket.
C: Slide the
bowl up against
the two back
tabs that are on
the stand.
D: Press down on
the bowl to press
t the two front
tabs on the stand
with the pins on
the front bottom
of the bowl.
Bowl Placement
Cat/Small Animal Stand Assembly Instructions
Page 6
Note: Hardware bag shipped on back of tower
8 - Small Black
Head Screws
To Next Page
Loading...