31
32
Use instant glue to secure the F36 (with
slot facing back) on the canopy closed to
F32.
Side view of the canopy with the F36 slots
facing back.
Apply the instrument sticker on the front
side of the pilot seat (under the machine
gun slot).
Place the F37 and vacuum formed engine
on the working table.
Spray the vacuum formed engine into
black. Wait for it dried enough.
Spread some UHU glue on the edges of
F37 and secure it onto the vacuum formed
engine. Drop some instant glue for better
securing.
Apply the decorative sticker on the
vacuum formed engine.
Place the vacuum formed engine on the
canopy and use 2.6 x 8mm tapping screws
to secure it in place.
Completion of the canopy.
Place the machine gun decal, F38 plastic
tube, F39 balsa barrel, and F40
combinations on the working table.
Insert the F38 into the F39 barrel. Use
instant glue to secure the F39 onto the
F40. Place a straight rule on top of it;
make sure the top of the machine gun is
straight.
Secure the F38 inside the barrel. Apply
the decorative sticker on the front of the
barrel. Use scissors to remove the excess
sticker.
To Next Page
Loading...
