To Next PageTo Next Page
Need help?Do you have a question about the Super Flying Model P-51D Mustang and is the answer not in the manual?
Nut Drivers Sizes| nut driver size 1 | 4mm |
|---|---|
| nut driver size 2 | 5mm |
| nut driver size 3 | 5.5mm |
| nut driver size 4 | 7mm |
| nut driver size 5 | 8mm |
Hex and Slotted Sizes| hex size 1 | Hex1.5 x Hex3.0 |
|---|---|
| hex size 2 | Hex2.0 x Hex3.5 |
| hex size 3 | Hex2.5 x Hex4.0 |
| slotted size 1 | (-)Slotted 3.0 x (+)Ph0 |
| slotted size 2 | (-)Slotted 4.0 x (+)Ph1 |
| slotted size 3 | (-)Slotted 2.0 x (+)Ph00 |
Additional Tools| glue gun voltage | 11.1V |
|---|---|
| propeller reamer size 1 | 5mm |
| propeller reamer size 2 | 6.5mm |
| propeller reamer size 3 | 8mm |
| propeller reamer size 4 | 9.5mm |
Important safety notice advising that the RC aircraft is not a toy and requires careful handling.
Describes two methods (epoxy or instant glue) for securely attaching the horizontal stabilizer.
Instructions for fitting rudder hinges and mounting the tail wheel assembly to the fuselage.
Details on assembling pushrods and connecting them to control horns on rudder and elevator.
Setup for throttle rod, ball-ends, and choke control for both Gas and Electric Power configurations.
Specifies recommended CG location and control surface throw distances for optimal flight.
