Need help?Do you have a question about the Super Star 120 and is the answer not in the manual?
General| Brand | Super Star |
|---|---|
| Model | 120 |
| Category | Transceiver |
| Language | English |
Highlights 120 channel operation, solid-state design, clear signal, quiet reception, and built-in SWR circuit.
Details channels, frequency range, tolerance, input voltage, dimensions, weight, indicators, and accessories.
Covers power output, modulation type, frequency response, and output impedance.
Details sensitivity, hum/noise ratio, image rejection, IF frequency, RF Gain, AGC, Squelch, and audio output.
Plan the location of the transceiver and microphone bracket before starting the installation.
Details mounting the bracket, connecting the antenna, and wiring the DC power input and ground.
Provides instructions for connecting the radio to positive or negative ground vehicle systems.
Discusses antenna types, operation efficiency, and connector details for 27-29 MHz operation.
Details the function of each control and indicator on the front panel, including Volume, Squelch, Gain, Band, Channel, and Indicators.
Describes the rear panel connection ports for power input, external speaker, and antenna.
Steps for turning on the unit, setting RF gain, volume, and band/channel for receiving.
Steps for checking SWR, selecting channels, transmitting, and adjusting mic gain.
Recommends periodic checks for SWR, electrical connections, antenna coaxial cable, and mounting hardware.
To Next Page
