DO NOT DRIVE FASTENERS on top of other
fasteners, or with the tool at too steep an angle:
the fasteners can ricochet causing personal injury.
FIRE FASTENERS INTO WORK SURFACE
ONLY. Do not drive cleat nails nor attempt to do
so, into hard or brittle materials such as steel,
concrete, or tile.
DO NOT DRIVE FASTENERS too close to the
edge of the workpiece. The workpiece is likely to
split, allowing the fasteners to y free or ricochet
causing personal injury.
STAY ALERT. Keep hands and body away from
the path of any potential red fastener. Watch
what you are doing & use common sense. Don’t
operate any tool when you are tired or under the
inuence of drugs or alcohol. Check prescriptions
to determine if there could be a problem.
GUARD AGAINST ELECTRIC SHOCK. Prevent
body contact with grounded surfaces: pipes,
radiators, ranges, and refrigerator enclosures.
Before driving fasteners into walls, oors,
or wherever “live” electrical wires may be
encountered, try to ascertain whether there is a
danger of shock.
KEEP WORK AREA CLEAR of obstructions.
STORE IDLE EQUIPMENT. When the tool is not
being used, it should be cleaned, and stored in a
clean dry place out of the reach of children.
EMPLOYERS must enforce compliance with the
safety warnings and all other instructions in this
manual. Keep it available for use by everyone
assigned to use this tool.
WARNING: The warnings, cautions, and
instructions detailed in this manual cannot cover
all possible conditions and situations that occur. It
must be understood by the operator that COMMON
SENSE AND CAUTION ARE FACTORS that
cannot be built into this product, but MUST BE
SUPPLIED BY THE OPERATOR.
20.
21.
22.
23.
24.
25.
26.
27.
IMPORTANT SAFETY INSTRUCTIONS
To Next Page
Loading...