Version V1.3
control is a signal connecting the first luminaire.
Question 4: After the controller is connected to the luminaire, the strobe flashes and the effect changes, and
the controller indicator shows normal.
A: ①The ground wire between the controller and the luminaire is not connected.
②The effect done in the SD card is incorrect. The lamp chip selected when the effect is made does not
match the chip of the actual lamp.
③ When editing effects on the software but did not lock the chip, the chip of the controller should be
attached to the corresponding chip of the luminaire. Refer specifically to the IC sequence of the sticker on
the controller.
④The power supply voltage of the luminaire is insufficient.
Question 5: The SD card cannot be formatted.
A: ：①First confirm that the protection switch on the side of the SD card has been unlocked. The direction
of unlocking is the end of the SD card gold needle.
②The protection lock has been designed as required, but it still cannot be formatted. If this happens,
most of the SD card readers are broken. Please replace the SD card reader (suggest to use a better quality
card reader like SSK (Biao wang) card reader).
③If the above operations cannot solve the formatting problem, please replace the SD card and retest.
To Previous Page
Loading...