Supermicro X10SRL-F - Page 15

Chapter 1: Introduction
1-5
Jumper Description Default
JBR1 BIOS Recovery Pins 1-2 (Normal)
JBT1 CMOS Clear See Chapter 2
JI
2
C1/JI
2
C2 SMB to PCI-E Slots Pins 2-3 (Disabled)
JPB1 BMC Enable/Disable Pins 1-2 (Enabled)
JPG1 VGA Enable Pins 1-2 (Enabled)
JPL1/JPL2 LAN1/LAN2 Enable Pins 1-2 (Enabled)
JPME2 Manufacture Mode Select Pins 1-2 (Normal)
JWD1 Watch Dog Enable Pins 1-2 (Reset)
Connector Description
Battery (BT1) Onboard Battery
COM1/COM2 COM1 (Port)/COM2 (Header)
Fan1 - Fan5, FanA System/CPU Fan Headers
J24 24-pin Main ATX Power Connector
JD1 Speaker/Buzzer (Pins 1-3: Power LED, Pins 4-7: Speaker)
JF1 Front Control Panel Header
JIPMB1 4-pin External BMC I
2
C Header (for an IPMI Card)
JL1 Chassis Intrusion Header
JOH1 Overheat/Fan Fail Indicator
JPI
2
C1 Power SMB (System Management Bus)
JPWR1 8-pin Secondary Power Connector
JSD1/JSD2 SATA DOM (Device On Module) Power Connector
JSTBY1 Standby Power Header
JTPM1 Trusted Platform Module/Port 80 Connector
JVR1 PWM SMB Programming (for debugging only)
LAN1/LAN2 Gigabit (RJ45) Ports (LAN1/2)
IPMI_LAN Dedicated IPMI LAN
I-SATA 0-9 (Intel PCH) Serial ATA (SATA 3.0) Ports 0-9 (6Gb/sec)
(PCH) Slot 1 PCI-Express 2.0 (x4 in x8 Slot)
(CPU) Slots 2-7 Six (6) PCI-Express 3.0 slots: 2 (x8 in x16), 2 (x8), 1 (x8//x4), 1 (x0//x4)
SP1 Internal Speaker/Buzzer
T-SGPIO 1/2/3 Serial Link General Purpose I/O Headers for SATA Connections
UID SW Unit Indentier Switch
USB 0/1 Back panel USB 2.0 Ports
USB 2/3 Back panel USB 3.0 Ports