12
Super X11DPH-i/X11DPH-T/X11DPH-Tq User's Manual
Quick Reference Table
Jumper Description Default Setting
JBT1 CMOS Clear Open (Normal)
JPME2 ME Manufacturing Mode Pins 1-2 (Normal)
JWD1 Watch Dog Timer Enable Pins 1-2 (Reset)
Connector Description
BT1 Onboard CMOS battery
COM1 COM port on the I/O back panel
FAN1-6, FANA/FANB System/cooling fan headers
IPMI_LAN Dedicated IPMI LAN port
I-SATA0~3, I-SATA4~7 SATA 3.0 Ports supported by the Intel PCH
JD1 Speaker/buzzer header (use in conjunction with an external speaker/buzzer) (optional)
JF1 Front control panel header
JHSSI High-Speed Serial Interface (HSSI) card header
JIPMB1 4-pin External I
2
C Header (for an IPMI card)
JL1
Chassis intrusion header (For this feature to work properly, please connect an optional external
speaker to the onboard speaker header at JD1.)
JNCSI Network Controller Sideband Interface (NCSI) header
JPI
2
C1 Power I
2
C System Management Bus (SMBus) header
JPWR1, JPWR2, JPWR4 8-pin power supply connectors
JPWR3 24-pin ATX main power supply connector
JRK1 Intel RAID key for NVMe SSD (Solid State Devices)
JSD1, JSD2 SATA DOM (Device-on-Module) power connectors
JSDCARD1 Micro SD card slot
JSTBY1 Standby power header
JTPM1 Trusted Platform Module (TPM)/Port 80 connector
JUIDB1 Unit Identifi er (UID) switch
LAN1, LAN2 10GbE LAN ports (for the X11DPH-T(q)) and Gigabit LAN ports (for the X11DPH-i)
M.2-C1, M.2-C2 PCI-E M.2 slots (w/VMD support) (See the notes below.)
MH4, MH11 M.2 mounting holes
(CPU1) SLOT1, SLOT3,
SLOT6, SLOT7
PCI-Express 3.0 x8 Slots supported by CPU1 (See the notes below.)
(CPU2) SLOT2, SLOT4,
SLOT5
PCI-Express 3.0 x16 Slot supported by CPU2 (See the notes below.)
S-SATA0, S-SATA1
Powered SATA 3.0 ports with support of Supermicro SuperDOM (Disk-On-Module)
Note 1: Intel VMD is supported by PCI-E Slot 1 - Slot 7, M.2-C1 ,and M.2-C2 slots. 2:
After you’ve enabled VMD in the BIOS on a PCI-E slot of your choice, this PCI-E slot
will be dedicated for VMD use only, and it will no longer support any PCI-E device.
To re-activate this slot for PCI-E use, please disable VMD in the BIOS. 3: To avoid
interference with other components, please be sure to use an add-on card that is fully
compliant with the PCI Standards on a PCI slot.
To Next Page
Loading...
