14
Super X11DPH-i/X11DPH-T/X11DPH-Tq User's Manual
Motherboard Features
Note: Please refer to the Memory Confi guration User Guide for the X11 UP/DP/MP
Motherboards posted on our website for detailed information on memory support.
Motherboard Features
CPU
• Dual Intel Xeon Scalable-SP or 2nd Generation Intel Xeon Scalable-SP (Socket P) processors with support of three
UltraPath Interconnect (UPI) links of up to 10.4 GT/s. (Note: QAT is supported by X11DPH-Tq only.)
Note: Both processors need to be installed for full access to the PCI-E slots, DIMM slots, and onboard controllers.
Refer to the block diagram to determine which slots or devices may be affected.
Memory
• Integrated memory controller supports up to 4TB of 3DS Load Reduced DIMM (3DS LRDIMM), Load Reduced DIMM
(LRDIMM), 3DS Registered DIMM (3DS RDIMM), Registered DIMM (RDIMM), Non-Volatile DIMM (NV-DIMM) DDR4
(288-pin) ECC memory with speeds of 2933*/2666/2400/2133 in 16 slots
Notes: 1. Up to 5TB of memory is supported with DCPMM modules installed. 2. 2933 MHz memory is supported
by 2nd Gen Intel Xeon Scalable-SP (82xx/62xx series) processors only.
DIMM Size
• Up to 256GB at 1.2V
Note 1: Memory speed support depends on the processors used in the system.
Note 2: For the latest CPU/memory updates, please refer to our website at http://www.supermicro.com/products/
motherboard.
Chipset
• Intel C621/C622/C627 Chipset (C621: is for X11DPH-i, C622 for X11DPH-T, and C627: X11DPT-Tq.)
Expansion Slots
• Four (4) PCI-Express 3.0 X8 slots supported by CPU1 (SLOT1, SLOT3, SLOT6, SLOT7 3; No Slot1 for X11DPH-Tq)
• Three (3) PCI-Express 3.0 X16 slots supported by CPU2 (SLOT2, SLOT4, SLOT5)
Baseboard Management Controller (BMC)
• ASPEED AST2500 BMC with IPMI 2.0 support
Graphics
• Graphics controller via ASPEED AST2500 BMC
Network Connection
• Intel C627 supports two 10 Gigabit LAN ports on the X11DPH-Tq
• Intel C622 supports two 10 Gigabit LAN ports on the X11DPH-T
• Intel C621 supports two Gigabit LAN ports (X11DPH-i)
• One (1) Dedicated IPMI LAN located on the rear I/O panel
I/O Devices
• Serial (COM) Port • One (1) serial port on the rear I/O panel
• SATA 3.0
• Eight (8) SATA 3.0 ports (I-SATA0~3, I-SATA4~7)
• Two (2) SATA 3.0 ports with SATA DOM power (S-SATA0, S-SATA1)
• RAID (PCH) • RAID 0, 1, 10
To Next Page
Loading...
