Chapter 4: BIOS
103
Custom EFI Logging Options
Log EFI Status Codes
Select EFI (Extensible Firmware Interface) Status Codes to log EFI status codes. Select Error
Codes to log EFI error codes. Select Progress Code to log the EFI progress code. Select
both to log both EFI error codes and progress codes. The options are Disabled, Both, Error
code and Progress code.
Note: After making changes on a setting, be sure to reboot the system for the changes
to take effect.
BMC Network Confi guration
The following items will be displayed:
• IPMI LAN Selection: This item displays the IPMI LAN setting. The default setting is Failover.
• IPMI Network Link Status: This item displays the IPMI Network Link status. The default
setting is Shared LAN.
• Current Confi guration Address Source: This item displays the source of the current IPMI
LAN address. The default setting is CHCP (Dynamic Host Confi guration Protocol).
• Station IP Address: This item displays the Station IP address for this computer. This should
be in decimal and in dotted quad form (i.e., 192.168.10.253).
• Subnet Mask: This item displays the sub-network that this computer belongs to. The value
of each three-digit number separated by dots should not exceed 255.
• Station MAC Address: This item displays the Station MAC address for this computer. Mac
addresses are 6 two-digit hexadecimal numbers.
• Gateway IP Address: This item displays the Gateway IP address for this computer. This
should be in decimal and in dotted quad form (i.e., 192.168.10.253).
• VLAN: This item displays the status of VLAN support.
Update IPMI LAN Confi guration
Select Yes for the BIOS to implement all IP/MAC address changes at the next system boot.
The options are No and Yes. If this option is set to Yes, the following items will display:
IPMI LAN Selection
Use this feature to select the type of the IPMI LAN. The options are Dedicated, Shared,
and Failover.
VLAN
Select Enabled to enable IPMI VLAN function support. The options are Enabled and Dis-
abled.
To Next Page
Loading...
