Supermicro X11SSW-TF - Page 62

62
X11SSW-TF/-4TF User Manual
SAN MAC
+
IPMI CODE
BIOS
LICENSE
BAR CODE
MAC CODE
DESIGNED IN USA
X11SSW-TF
REV:1.01
JPW2
JSTBY1
JSD2 JSD1
JIPMB1
I-SGPIO1
I-SGPIO2
JSXB1C
JSXB1A
JSXB1B
JD1
JBAT1
SP1
JF2
JF1
JUIDB1
LED1
LED3
JL1
JPW1
JPI2C1
I-SATA5
I-SATA0
I-SATA1
I-SATA4
I-SATA3 I-SATA2
JTPM1
JBR1
JWD1
JLED1
JPME2
JPL2
JPL1
JI2C2
JI2C1
JPB1
JPG1
JBT1
DIMMA1
DIMMA2 DIMMB1
DIMMB2
BMC
PCH
JNVME1
LED2
FAN6
FAN5
VGA
FAN4 FAN3
LAN1/2
USB6/7
(3.0)
USB0/1
IPMI_LAN
COM1
FAN2
FAN1
USB9/10(3.0)
USB8(3.0)
USB4/5
USB2/3
COM2
CPU
LAN3/4
LAN1/2
CTRL
LAN3/4
CTRL
J3
1. BMC Enable
2. NVMe Connection
1
BMC Enabled
Jumper JPB1 allows the user to enable the embedded Baseboard Management Controller
(BMC) to provide IPMI 2.0/KVM support on the motherboard. See the table below for jumper
settings. The default setting is BMC Enable.
BMC Enable
Jumper Settings
Jumper Setting Denition
Pins 1-2 BMC Enabled
Pins 2-3 Disabled
NVMe Connection
Close pins 1 and 2 to manually enable the NVMe add-on card support on the motherboard,
which will allow one of PCIe 3.0 x8 links to always run at dual PCIe 3.0 x4. See the table
below for jumper settings. The default setting is Auto.
Note: Use only NVMe add-on cards that have been validated by Supermicro. For the
latest updates, please refer to our website at http://www.supermicro.com/products/
motherboard.
NVMe Connection
Jumper Settings
Jumper Setting Denition
Pins 1-2 Manual
Pins 2-3 Auto (Default)
2