EN-11
EN-12
MAINTENANCE & SAFETY
Precautions & General Maintenance
· Place the set on a hard and flat surface so that the
system does on tilt.
· Do not expose the set, batteries or CDs to
humidity, rain, sand or excessive heat caused by
heating equipment or direct sunlight.
· Do not cover the set. Adequate ventilation with a
minimum gap of 6 inches between the ventilation
holes and surrounding surfaces is necessary to
prevent heat build-up.
· The mechanical parts of the set contain self-
lubricating bearings and must not be oiled or
lubricated.
· To clean the set, use a soft dry cloth. Do not use
any cleaning agents containing alcohol, ammonia,
benzene or abrasives as these may harm the housing.
CD player and CD handling
· The lens of the CD player should never be touched!
·Sudden changes in the surrounding temperature can cause condensation to form and the lens of your
CD player to cloud over. Playing a CD is then not possible. Do not attempt to clean the lens but leave the set
in a warm
environment until the moisture evaporates.
· Always close the CD door to keep the CD compartment dust-free. To clean, dust the compartment with a soft
dry cloth.
· To clean the CD, wipe in a straight line from the centre towards the edge using a soft, lint-free cloth. Do not
use cleaning agents as they may damage the disc.
· Never write on a CD or attach any stickers to it.
TROUBLESHOOTING
TROUBLESHOOTING
Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair.
Do not open the unit as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints. Consult your dealer or service center.
WARNING: Under no circumstances should you try to repair the set yourself. as this will invalidate the warranty.
--Problem and Solution:
No sound.
Volume not adjusted
No Power
-Power cord not securely connected
-Connect the AC power cord properly
-Batteries dead/incorrectly inserted
-Insert (fresh) batteries correctly
Display does not function properly
Any reaction to operation of any of the controls:
--Electrostatic discharge
·Switch off and unplug the set. Reconnect after
a few seconds n
CD/MP3/USB playback does not work
-CD/MP3/USB badly scratched/dirty
-Replace/clean CD/MP3/USB (see maintenance)
The CD/MP3 skips tracks
-CD/MP3 damaged or dirty
-Replace or clean CD/MP3
-Program is active, quit program mode.
CD badly scratched or dirty
·Replace/clean CD, see Maintenance
no disc indication
CD-R,is blank or the
disc is not finalized
-Use a finalized CD-R.
Poor cassette sound quality
-Dust and dirt on the heads,etc.
*Clean deck parts etc, see Maintenance
-Use of incompatible cassette types (METAL or CHROME)
*Only use NORMAL (IEC I) for recoding
Recording does not work
-Cassette tabs may be broken
*Apply a piece of adhesive tape over the missing tab space
Environmental information
We have done our best to reduce the packaging and make it easy to separate into 3 materials:
Cardboard, paper pulp and expandable polyethylene.
Your set consists of materials which can be recycled if disassembled by a specialized company.
Please observe the local regulations regarding the disposal of packaging, dead batteries and old
equipment..
To Previous Page
Loading...