Why Superwinch Certus Wireless Remote Control system does not have enough effective range?
The Superwinch Remote Control system might not have enough range because the receiver is mounted incorrectly, surrounded by metal, or the battery is weak. Refer to the mounting instructions and consider changing the battery.
What to do if Superwinch Certus Wireless system does not operate in the proper direction?
If your Superwinch Remote Control system isn't operating in the correct direction, it's likely due to incorrect wiring of the harness. Verify the connections according to the installation instructions.
What to do if Superwinch Certus Wireless Remote Control receiver shows no reaction after supply current has been connected?
If the Superwinch Remote Control receiver shows no reaction after connecting the power and the green LED doesn't light up when you press the transmitter's power button, it could be due to unavailable supply current or reversed connections. Check the polarity, test the current into the receiver, and ensure the main power is turned on.
Why Superwinch Certus Wireless receiver can be taken out of standby mode but quickly shuts down again?
If your Superwinch Remote Control receiver exits standby mode but quickly shuts down, it could be due to another transmitter operating on the same frequency. Try deactivating the other transmitter.
Detailed steps to program individual buttons on the wireless transmitter unit.
Identifies common system issues, their causes, and recommended solutions.
General| Type | Wireless Remote Control |
|---|---|
| Range | Up to 50 feet |
| Power Source | Battery |
| Battery Type | CR2032 Lithium Coin Cell |
| Water Resistance | IP67 |
| Compatibility | Superwinch Winches |
| Battery Life | Up to 1 year |
To Next Page