©2017 Skier’s Choice, Inc.
50
Ballast Trouble Shooting Guide
Problem Possible Cause Action Correction
Pump turns on, but does
not pump water
Pump will not turn on
Pump will not turn on
Pump will not turn on
Pump not priming
System needs reset
Ballast breaker is tripped
Ballast power wires not
connected to PDM
1)Water intake ball valves are not open
2)Kink in hose
3)Impeller wornCheck ballast power
wires at the PDM
Check power to all areas
Check 60 amp ballast breaker at the
engine compartment
Check ballast power wires at the PDM
1)Open ball valves
2)Check hoses for kinks and
straighten as needed
3)Check hose connections and
tighten if loose.
4)Replace Impeller
Turn power o to the system at the
breaker and then back on and test
pump
Reset ballast breaker
Connect power wires to PDM
To Next Page
Loading...
