©2017 Skier’s Choice, Inc.
86
Unloading Procedure
To unload the boat, use the following procedure as a guide:
1. Make sure that all drain plugs are securely in place.
2. Unplug light cord before backing into the water.
3. With Bow Eye Hook fastened, back the trailer until the water level is approximately 1 inch below the top of the trailer fenders. NOTICE:
Ramp slopes vary, so actual level of water on trailer may be dierent. (NOTE: Caution on this page!).
4. Follow the cold start procedure recommended in this manual.
5. After starting the engine, remove Bow Eye Hook.
6. With engine idling, center steering wheel, engage transmission and slowly pull throttle into reverse. Ease back on the throttle lever
until the boat starts to move.
NOTE: DO NOT attempt to use excessive power to
free the boat from dry carpet runners. Power o
of the trailer only when the boat has oated free.
If the trailer is not submerged to the correct
depth, the bow of the boat could drop when
powering off incorrectly, possibly damaging
the boat.
Roll driver’s side window of tow vehicle down
prior to backing down ramp. Should the vehicle
slip into the water, the driver can escape through
open window.
NOTE: Because your Supra is a true inboard, when
backing up, the stern will have a tendency to drift
to due to prop rotation.
To Next Page
Loading...
