©2017 Skier’s Choice, Inc.
87
Loading Procedure
To load the boat on the trailer, position the trailer in the water with approximately 1 inch of the top of the fender showing.
1. Idle/coast the boat onto the trailer using as little power as possible, while keeping it centered between the guide poles.
2. Power slowly forward until the bow eye roller contacts.
3. Winch hook must be attached to bow eye and tightened before trailering.
DO NOT Power onto the trailer during rough conditions!
Once correctly positioned on the trailer, switch o ignition.
DO NOT OVER-POWER onto trailer or damage may
occur to the boat and/or the trailer!
The trailer must be positioned for the correct water depth
for loading or you may damage the boat. Varying ramp
angles require dierent procedures. In general, the steeper
the ramp, the more shallow the trailer should be positioned
in the water. Your local dealer can help you understand this,
should you require additional assistance.
To Next Page
Loading...
