©2017 Skier’s Choice, Inc.
84
NOTICE: If your hitch ball has an excessive at spot
on top, the latch may not engage properly. If the
latch does not catch, check with your dealer or hitch
installer before trailering.
Connecting the Trailer
When connecting the trailer to your tow vehicle, use the
following procedure:
1. Raise the tongue with the trailer jack. Position the
trailer tongue directly over the 2” ball, and lower
the jack until the tongue goes all the way down
over the ball.
2. Press down on the latch until it locks on the ball
with a “click.”
3. Insert the locking pin into the tongue. Lock pin hole
is on the side of the tongue.
4. When all weight is o the trailer jack, pull the jack
lock pin and rotate the jack to the horizontal position
and re-lock the pin.
5. Attach the safety cables to the tow vehicle hitch.
Cross the cables and wrap them around each other
once or possibly twice allowing just enough slack to
permit tight turns of the vehicle and trailer.
6. Plug the trailer lights connector to the vehicle
harness.
7. Clip the brake lockout cable to the vehicle hitch.
To Next Page
Loading...
