suprema BioEntry Series - User Manual

BioEntry™ Installation Guide
BioEntry™ Smart / Pass
Ver. 0.96c
Suprema Inc and BioEntry™ are registered trademarks of Suprema Inc. All
rights reserved. No part of this work covered by the copyright hereon may be
reproduced or copied in any form or by any means - graphics, electronic, or
mechanical, including photocopying, recording, taping, or information and
retrieval systems - without written permission of Suprema Inc. Any software
furnished under a license may be used or copied only in accordance with
the terms of such license.
Suprema Inc reserves the right to modify or revise all or part of this
document without notice and shall not be responsible for any loss, cost or
damage, including consequential damage, caused by reliance on these
materials.
Copyright © 2005 by Suprema Inc.

Summary

Suprema Warranty Policy

Disclaimers

About the BioEntry Series

About Suprema Inc

About This Guide

Before you start with BioEntry

Included items

Lists the components included with the BioEntry unit.

Required items

Details the essential items needed for BioEntry installation and operation.

Optional items

Describes optional accessories that can enhance BioEntry functionality.

Installing BioEntry

Connecting wires

Explains the connection of various wires for the BioEntry device.

Power connection

Details the procedure for connecting the BioEntry to a power supply.

Connecting to a Wiegand compatible reader

Describes how to connect the BioEntry to Wiegand readers.

Connecting to a Wiegand compatible access controller

Explains the connection of BioEntry to access controllers via Wiegand interface.

Connecting to the host computer

Outlines methods for connecting the BioEntry to a host computer.

Connecting via RS-232 C interface

Details the RS-232C connection method for host computer communication.

Connecting via RS-485 interface for a full duplex BioEntry network system

Describes the RS-485 connection for full duplex BioEntry networks.

Connecting via RS-485 interface for a half duplex BioEntry network system

Explains the RS-485 connection for half duplex BioEntry networks.

Connecting via auxiliary interface

Details the connection using the auxiliary port for laptops.

Disassembling

Provides instructions on how to disassemble the BioEntry device.

Mounting back plate

Guides on installing the mounting back plate to a wall surface.

Reassembling the BioEntry

Details the process of reassembling the BioEntry unit after installation.

Examples for BioEntry installation

Building a new system

Describes setting up a new access control system with BioEntry.

Installing BioEntry Pass

Details the installation process for the BioEntry Pass model.

Installing BioEntry Smart

Outlines the installation procedure for the BioEntry Smart model.

Adding BioEntry to existing access control system

Explains how to integrate BioEntry into existing access control systems.

Specifications

Fingerprint Authentication Specifications

Provides detailed specifications for fingerprint authentication performance and sensors.

Data storage

Details the template and log storage capacities of the BioEntry device.

General Specifications

Covers general operational parameters like voltage, temperature, and humidity.

Operating range

Specifies the environmental and electrical operating conditions for BioEntry.

Smart card specifications

Lists the technical specifications related to smart card functionality.

Material information

Details the materials used in the construction of the BioEntry device.

RTC battery specification

Provides specifications for the Real-Time Clock (RTC) battery.

Contact Information

suprema BioEntry Series Specifications

General

Ingress Protection	IP65
Power Supply	12VDC
Resolution	500 dpi
Fingerprint Sensor	Optical
RFID	Yes
Memory	Internal Flash Memory
Fingerprint Capacity	Up to 10, 000
Interfaces	RS485, Wiegand
Operating Temperature	-20°C
Operating Humidity	80%, non-condensing