Model: Supreme Plus Revised, August 2008
12
Figure 16 - Not recommended
To determine the preset amount, the user will have to use the fireplace for several days, placing the control handle at
different positions between minimum and maximum.
After establishing a position for the control, push the control handle fully inwards and then pull it back when starting a fire
in order to maximize the combustion air. The combustion air will gradually reduce to the preset setting when the wood will
start to burn properly.
Note: Once the control handle has been pushed inwards, it is not possible to reduce the combustion air by rotating the
control handle. The fireplace must burn at a good rate and for a given period of time in order to allow the control to
gradually reduce the amount of combustion air to the preset amount.
WARNING: READ THE OWNER’S MANUAL CAREFULLY. Also read the following brief instructions before
using your fireplace.
Note: It is important to assure that a flame is maintained. If the flame is not maintained, reestablish it by cracking the door
open again. Do not leave the fireplace with the door unlocked without supervision.
Caution: The wood should be placed away from the door to avoid damage to the glass.
WARNINGS: Over firing the unit may result in overheating and can damage the fireplace or/and result in fire
hazards. The maximum firewood load must not exceed 4 medium sized logs (approximately 30 pounds). Open the
door to reload only when the wood has been reduced to charcoal, otherwise there is a risk of smoke infiltration into
the house.
• This fireplace has been designed to burn with the door closed. When the fireplace
is functional, the door should only be opened when adding more wood.
STARTING THE FIRE
Assure that all the safe precautions mentioned in the owner’s manual are being
respected.
1. Place 2 logs at the hearth of the firebox (Figure 17).
2. Place a fire starter on top of the logs.
3. Light the fire starter
4. Place 1-2 logs on top of the fire starter
5. Close the door
6. Activate the control by pushing and retracting it.
Summary of Operation of the Automatic Air Control:
1. Select the burning rate for the season.
2. Push and retract the control handle when starting the fire or when adding wood.
ADDING A NEW CHARGE OF WOOD
When the wood has been reduced to charcoal, add a new load.
1. Bring the wood near the fireplace.
2. Unlock the door for 2-3 minutes to activate the remaining charcoal.
3. Open the door slowly and add 2-3 logs.
4. Push the door closed without locking it. Hold the door closed until you establish
a flame.
5. W a solid flame has been established, lock the door and activate the control by
pushing and retracting it.
Note: It is important to assure that a flame is maintained. If the flame is not
maintained, re-establish it by cracking the door open again. Do not leave the
fireplace unsupervised with the door unlocked.
Figure 17 - Recommended
To Next Page
Loading...