Suraielec Smart Wi-Fi Box Timer Switch
SKU: T40W
Safety Section
WARNING
Risk of Fire or Electrical Shock
• This smart box should be installed by a licensed electrician. Turn power off at main panel before servicing this switch or the equipment it controls.
• Disconnect power at the circuit breaker(s) or disconnect switch(es) before installing or servicing.
• Installation and/or wiring must be in accordance with national and local electrical code requirements.
• This enclosure does not provide grounding between conduit connections. When metallic conduit is used, you must also install grounding type bushings
and jumper wire.
• Use #14- #8 AWG wires, rated at least 75°C (167°F)-COPPER conductors ONLY.
• Make sure there is no wire insulation under the terminal plate on the timer switch connector. Firmly tighten terminal screws.
• Do not remove the insulator that is covering terminals.
• KEEP THE DOOR CLOSED AT ALL TIMES when not servicing.
• Installation, Operating and Safety Instructions - Instructions for installation and use of this product are provided by the manufacturer. "Make sure to
use this product together with 40A circuit breaker in the upstream" stated in the manual
Specifications
Product Illustration
Light Chart
Input
120- 240/277VAC, 60Hz Detects voltage automatically (NO DIP SWITCH SETTING REQUIRED)
Contact Ratings
- 40A Resistive 120 to 277 VAC;
- 30A General Purpose 120 to 277 VAC;
- 20A Resistive, 30VDC;
- 1HP, 120 VAC;
- 2HP, 240VAC;
- 20A Ballasted load 120 to 277 VAC;
- 15A Tungsten, 120 VAC;
- 5A Tungsten, 250VAC;
- 800VA, Pilot Duty, 120VAC;
- 720VA, Pilot Duty, 240 VAC;
- TV-5, 120VAC
System
- Wireless Type: 2.4GHz Only IEEE 802.11 b/g/n
- Wi-Fi Range: 80Ft (Free Area)
- APP：Smart life
- IOS：8.0 or higher
Android：4.1 or higher
Terminal range
- #14-#8 AWG
Operating temperature:
- -40°F to 149°F
Load Indicator
Power Indicator
Red
Solid
Solid
No Light
No Light
Blinks rapidly
Blinks slowly
until off
Blue
Blue
Name
Color
Status Status
FIG.1 Product IIlustration
Input normal
Input abnormal
Power is on
Power is off
Configuration is
success
Resetting/Enter into
network configuration
Wi-Fi LED Indicator
Wi-Fi LED Indicator
Power Button &
Program Button
Clip
Load Indicator
Power Indicator
Plastic Insulator
Knockouts
1
Open the plastic insulator
Grounded Terminal
To Next Page
General