E1L & E2L Outdoorsman
Introduction
The E1L and E2L Outdoorsman LED flash-
lights are fitted with a three-watt LED module.
Powered by 3-volt lithium batteries (E1L -1 bat-
tery, E2L - 2 battery), each feature digital current
regulation circuitry that matches the LED’s cur-
rent requirements to the batteries’ output to
achieve a consistent level of light output for the
useable life of the batteries. The E1L and E2L
feature a click-on/click-off tailcap pushbutton
switch.
Light Activation
Partially depress the tailcap pushbutton switch
for momentary activation. Note: If light fails to
function, the tailcap may be in the lock-out posi-
tion; the tailcap must be tightened for the light to
activate. For constant light, fully depress the
tailcap pushbutton switch to the “click-on” posi-
tion.
CAUTION: The E1L and E2L are high-output
lighting devices and should not be left on unat-
tended. External surface temperature will rise
during prolonged operation; this is a normal
operating phenomenon.
Lock-out Tailcap
The lock-out position disables the pushbutton
switch and prevents accidental light activation
during storage or transportation. From the
momentary-on position, rotate the tailcap
approximately 1.5 turns counter-clockwise to
lock the light in the off position.
To Next Page
Loading...
