Need help?Do you have a question about the SurgeX SX-DS-154 DEFENDER SERIES MULTIPAK and is the answer not in the manual?
General| Model | SX-DS-154 |
|---|---|
| Series | Defender Series Multipak |
| Number of Outlets | 4 |
| Amperage | 15A |
| Voltage | 120V |
| Maximum Current | 15 Amps |
| Operating Voltage | 120V |
| Frequency Range | 50/60 Hz |
| Cord Length | 6 ft |
| Warranty | Lifetime |
Contact SurgeX Customer Service if your unit was damaged during shipping.
Turn off equipment and unplug its power cord from the wall outlet before connecting.
Connect AC power cords to MultiPak receptacles, verify total amperage does not exceed circuit rating.
Green 'System On' LED indicates correct wiring and acceptable voltage (105-130 VRMS).
Red 'Wiring Fault' LED signifies incorrect outlet wiring; contact an electrician.
No LED illumination means no voltage or unacceptable voltage; check outlet or contact support.
Contact SurgeX at 1-800-645-9721 or visit surgex.com for support and warranty information.
To Next Page
