Why is my SurgeX XU115 operating in battery mode?
If your SurgeX UPS operates in battery mode even when AC power is available, it might be due to a tripped input AC circuit breaker. Try resetting the circuit breaker by pressing the plunger back in. If the AC circuit breaker trips after the UPS starts up, consider reducing the load on the UPS.
What to do if SurgeX XU115 does not provide expected runtime?
If your SurgeX UPS does not provide the expected runtime, the batteries might be weak or nearing the end of their service life. To address this, charge the batteries for 8 hours and then retest. If the runtime remains less than expected, the batteries may require replacement, even if the Weak/Bad Battery LED is not lit.
What to do if AC Mode LED is illuminated, but there is no output from SurgeX UPS?
If the AC Mode LED is illuminated but there is no output from your SurgeX UPS, it's possible that the UPS is being controlled through its communications port. Try disconnecting the computer cable from the UPS and pressing the On button. If the UPS then functions normally, it indicates that the software was controlling the UPS.
What to do if Fault LED is illuminated on SurgeX XU115 UPS?
If the Fault LED is illuminated on your SurgeX UPS, it indicates that the UPS has detected an internal fault. In this case, you should call for service.
How to turn on SurgeX XU115?
To turn on your SurgeX UPS, press and release the On/Off button.
Connects the unit to a 120V AC receptacle, following safety guidelines.
Connects the internal batteries for operation, ensuring proper wiring.
Plugs external devices into UPS/surge outlets for protection.
Optional connection for monitoring software via USB.
Optional connection for phone/network line protection.
Details how the UPS batteries are charged when connected to AC.
Procedure for powering the UPS on and off.
Details about the USB communication protocol.
Information about the included monitoring software.
Step-by-step guide for replacing the UPS batteries.
Details surge protection capabilities and ratings.
Provides general technical and operational details of the unit.
Surge Protection Specifications| surge energy rating | 6, 000 volts/3, 000 amps |
|---|---|
| let through voltage (6,000 volt surge) | 0 volts |
| maximum applied surge voltage | 6000 volts |
EMI/RFI Filtering| EMI/RFI filter, normal mode (50-ohm load) | 40 dB @ 100 kHz; 50 dB @ 300 kHz; 50 dB @ 3 MHz; 50 dB @ 30 MHz |
|---|---|
| EMI/RFI filter, common mode (50-ohm load) | 18 dB @ 300 kHz; 30 dB @ 1 MHz; 50 dB @ 5 MHz; 50 dB @ 20 MHz |
Operating Environment| operating temperature | 32°F to 104°F (up to 5, 000 ft above sea level) |
|---|---|
| operating elevation | 32°F to 95°F (5, 001-10, 000 ft above sea level) |
| storage temperature/relative humidity | 5°F to 113°F / 0 - 95% non-condensing |
Weight and Dimensions| rack size | 2U |
|---|---|
| unit dimensions (H x W x D) | 3.5” x 19.0” x 10.5” |
| unit weight | 32.0 lbs. |
To Next Page
