To Next PageTo Next PageWhy is the crank on my Suspa Lifting System difficult to turn?
If the crank on your Suspa Lifting System turns with difficulty, it might be because you've reached the upper or lower limit. Stop rotating the crank. Alternatively, the workstation movement might be obstructed; ensure there's clearance. Finally, check if the system load exceeds the rating and remove weight if needed.
What to do if the crank on my Suspa Lifting System turns but does not extend or retract?
If the crank on your Suspa Lifting System turns but doesn't extend or retract the system, ensure the crank handle is fully installed onto the pump shaft. If the issue persists, it might be due to a broken pusher block, in which case you should contact Suspa® Incorporated for a replacement pump.
Why is there uneven lift cylinder retraction in my Suspa Lifting System?
Uneven lift cylinder retraction in a Suspa Lifting System can occur due to insufficient lift cylinder load. Try adding load to the system. It also can be caused by flexible tubing lengths being too long. Contact Suspa Incorporated for tube shortening instructions.
General| Brand | Suspa |
|---|---|
| Model | MOVOTEC |
| Category | Lifting Systems |
| Language | English |
