SUTPHEN TOWERS, INC. 2012
Manual-2012
_SL75-SA75-SP70.docx
Page 12 of 55
8/31/2012
AERIAL TOWER SET-UP
1. Leave transmission in neutral.
2. Set parking brake.
3. Engage PTO at engine idle.
4. Exit cab.
5. Place wheel chocks approximately 3” in front of and behind rear tires.
6. Pull out operator's step.
7. Set ground pads and stabilizers. Do this by pressing the “LOWER” control switch (See
figure 1). This is located near the control box, on the vertical face of the compartment
adjacent to the pump panel. Next, use the high speed until the jacks are all the way out
and down. Then, set the pins in place and ensure that both locks are down.
Power lines should always be observed and avoided at all times.
This Aerial Device is rated for service in winds up to 30 mph sustained or
50 mph gusts.
To Next Page
Loading...