Suzuki 2006 GSR600 User Manual

GSR600
99500-36160-01E

Suzuki 2006 GSR600 Specifications

General

Displacement	599cc
Compression Ratio	12.5:1
Fuel System	Fuel injection
Ignition	Digital/transistorized
Transmission	6-speed constant mesh
Final Drive	Chain
Lubrication	Wet sump
Front Suspension	Telescopic, coil spring, oil damped
Rear Suspension	Link type, coil spring, oil damped
Front Brakes	Dual hydraulic disc
Rear Brakes	Single hydraulic disc
Front Tire	120/70ZR17M/C (58W), tubeless
Rear Tire	180/55ZR17M/C (73W), tubeless
Overall Height	1, 075 mm (42.3 in)
Wheelbase	1, 440 mm (56.7 in)
Engine Type	4-stroke, liquid-cooled, DOHC
Fuel Tank Capacity	16.5 L (4.4 US gallons)
Overall Length	2090 mm
Overall Width	795 mm
Seat Height	785 mm
Ground Clearance	130 mm
Bore x Stroke	67.0 mm x 42.5 mm

Summary

General Information

Warning, Caution, and Note

Explains the meaning of signal words like WARNING, CAUTION, and NOTE.

General Precautions

Lists important safety precautions for servicing the motorcycle.

Fuel, Oil and Engine Coolant Recommendation

Recommends specific types and grades of fuel, oil, and coolant.

Specifications

Provides detailed technical specifications for the motorcycle's components.

Periodic Maintenance

Periodic Maintenance Schedule

Outlines recommended intervals for periodic service work.

Periodic Maintenance Chart

A table detailing service items and their intervals (km/months).

Lubrication Points

Identifies major lubrication points on the motorcycle for smooth operation.

Air Cleaner

Procedure for inspecting and replacing the air cleaner element.

Spark Plug

Instructions for inspecting, checking heat range, and replacing spark plugs.

Engine Oil and Oil Filter

Procedures for replacing engine oil and the oil filter.

Brake

Covers inspection of brake pads, pedal height, and fluid level.

Engine

Engine Components Removable with Engine in Place

Lists engine parts that can be removed/reinstalled without engine removal.

Engine Removal and Installation

Step-by-step guide for removing and installing the engine from the frame.

Engine Disassembly

Detailed instructions for disassembling engine components.

Clutch

Procedures for inspecting and servicing the clutch assembly.

Engine Components Inspection and Service

Covers inspection and service for various engine components.

Crankshaft and Conrod

Procedures for checking crankshaft runout and conrod dimensions.

Engine Reassembly

Step-by-step guide for reassembling the engine after service.

FI System Diagnosis

Precautions in Servicing

Important safety points for servicing the FI system.

Electrical Circuit Inspection Procedure

General methods for checking circuits using ohmmeters and voltmeters.

Self-Diagnosis Function

Explains the ECM's self-diagnosis modes (User and Dealer).

TPS Adjustment

Procedure for adjusting the Throttle Position Sensor.

FI System Troubleshooting

Guides on analyzing customer complaints and performing visual inspections.

Malfunction Code and Defective Condition

Lists DTCs, detected items, failure conditions, and checks.

C11 (P0340) CMP Sensor Circuit Malfunction

Troubleshooting procedure for CMP sensor circuit issues.

C12 (P0335) CKP Sensor Circuit Malfunction

Troubleshooting procedure for CKP sensor circuit issues.

C13 (P0105-H/L) IAP Sensor Circuit Malfunction

Troubleshooting procedure for IAP sensor circuit issues.