45
DIAGNOSTIC SYSTEM
If abnormal conditions exist in any sensor sig-
nal being input to the control unit, the self-diag-
nostic system warns of the abnormal condition.
If this system activates, the “Check Engine X –
X” and check engine icon are displayed on
screen, and the buzzer sounds.
The “Check Engine X – X” is cleared when any
of the buttons are pressed in the gauge. How-
ever, the check engine icon is displayed until
the cause is addressed.
Also incorporated is a fail-safe provision that
allows the operation at a restricted speed even
under such a failure condition.
NOTE:
• If equipped with Keyless Start System:
This diagnostic code is designed to appear
while the Keyless Start System is in ON
state.
If not equipped with Keyless Start System:
This diagnostic code is designed to appear
while the ignition key is turned on.
• The buzzer sound with diagnostic system
activating will be canceled by pushing the
ignition key in.
NOTICE
If the diagnostic system activates while you
are operating your outboard motor, there is an
abnormal condition in one of the sensor sig-
nals of the control system.
Consult your authorized Suzuki marine dealer
for repair of the control system.
OIL CHANGE REMINDER
SYSTEM
This system informs the operator of the time for
replacing engine oil on the basis of the mainte-
nance schedule.
The system is designed to register the total
operating hours of the outboard motor and
function its operation when the preprogrammed
hours have reached.
(Refer to the INSPECTION AND MAINTE-
NANCE section and the last page.)
SYSTEM ACTIVATION
When the total operating hours have reached
the preprogrammed hours, the “Change Oil” is
displayed on screen, and the buzzer sounds.
This indication will repeat until you cancel the
system activation.
To Next Page
Loading...
Need help?
General
