48
If not equipped with Keyless Start System:
1. Squeeze the fuel line priming bulb several
times until you feel resistance.
2. Side mount type:
Make sure the warm-up lever is in the fully
closed position.
3. Turn the ignition key to the “ON” position,
then observe the monitor-tachometer indica-
tion. If nothing abnormal is indicated, then
turn the key to the “START” position to start
the engine.
After returning the ignition key to “ON” posi-
tion from “START” one, starter motor con-
tinue to turn for 4 seconds until engine start.
NOTE:
The continuous operating time of the starter
motor is set at five seconds.
When this time is exceeded, the starter motor
will automatically stop.
If the motor stops, wait about ten seconds for
the motor to cool down and try again.
4. Warm up the engine for about 5 minutes.
NOTICE
If you hold the ignition key at the
“START” position to start the engine, the
starter system can be damaged.
Turn the ignition key to the “START” posi-
tion once and release it to start the
engine.
The engine will crank continuously for 4
seconds or until the engine starts.
NOTICE
If the OIL lamp remains lit while operating
the outboard, the oil level may be low
enough to damage the engine.
Stop the engine and check the oil level.
To Next Page
Loading...
