Suzuki DF60A - TILT BRACKET SETTING AND PRECAUTIONS

31
TILT BRACKET
DF40A (T/TH), DF50A (T/TH), DF50AV
(T/TH), DF60A (T/TH), DF60AV (T/TH)
MODEL
The Tilt Bracket is provided so you can support
the motor in a tilted position for non-moving
engine support.
To set the Tilt Bracket:
1. Tilt the motor all the way up using the Power
Trim and Tilt.
2. Pull down the Tilt Bracket as shown in the
illustration.
3. Lower the motor using the Power Trim and
Tilt, until the motor is supported by the Tilt
Bracket.
 CAUTION
The remote Power Trim and Tilt switch will
work when the ignition switch is off. If some-
one activates the switch while you are moving
the tilt bracket your hand could be injured.
Keep all persons away from the remote Power
Trim and Tilt switch while you are moving the
tilt bracket.
DF50AV/60A/60AV
DF40A/50A
NOTICE
Damage can occur if you use the tilt bracket
other than when the boat is moored or is oth-
erwise stationary.
The tilt bracket relieves pressure from the
power trim and tilt and should only be used
when the boat is stationary. Do not use the tilt
bracket when trailering your boat and motor.
Refer to the TRAILERING section of this man-
ual.