Suzuki GSX-S1000 User Manual

6-27
5. Turn the oil filter 5 counterclock-
wise and remove it with a Suzuki
“cap type” oil filter wrench or a
“strap type” filter wrench of the
proper size.
6. Wipe off the mounting surface 6
on the engine where the new filter
will be seated with a clean rag.
7. Smear a little engine oil around
the rubber gasket 7 of the new oil
filter.
8. Screw the new filter by hand until
the filter gasket contacts the
mounting surface (a small resis-
tance will be felt).
NOTE: To tighten the oil filter properly,
it is important to accurately identify
the position at which the filter gasket
first contacts the mounting surface.
NOTICE
Failure to use an oil filter with the
correct design and thread specifi-
cations can damage your motor-
cycle’s engine.
Be sure to use a genuine Suzuki
oil filter or an equivalent one
designed for your motorcycle.

Suzuki GSX-S1000 Specifications

General

Engine Type	4-stroke, 4-cylinder, liquid-cooled, DOHC
Bore x Stroke	73.4 mm x 59.0 mm
Compression Ratio	12.2:1
Fuel System	Fuel injection
Starter	Electric
Transmission	6-speed constant mesh
Final Drive	Chain
Front Suspension	Inverted telescopic, coil spring, oil damped
Rear Suspension	Link type, coil spring, oil damped
Front Brakes	Disc, twin
Rear Brakes	Disc
Front Tire	120/70ZR17M/C (58W), tubeless
Rear Tire	190/50ZR17M/C (73W), tubeless
Displacement	999 cm3
Overall Length	2115 mm
Overall Width	810 mm
Overall Height	1080 mm
Wheelbase	1460 mm
Ground Clearance	140 mm
Seat Height	810 mm
Curb Weight	214 kg
Fuel Tank Capacity	19 L (5.0 US gal)