3-37
BEFORE DRIVING
80TS - 01E
Lane change signal (if equipped)
68PM00235
Move the lever partially upward or down-
ward to turn right or left and hold the lever
in the moved position.
• The turn signal and its indicator flash
while the lever is held at the moved posi-
tion.
• The turn signal and its indicator flash 3
times even if you returned the lever
immediately after the activation.
NOTE:
• The turn signal and its indicator can be
set whether they flash 3 times after the
turn signal lever is returned via the infor-
mation display. Refer to “Information Dis-
play” in “INSTRUMENT CLUSTER”
section.
• You can customize the setting for the
number of flashing times of the turn sig-
nal and its indicator (1 to 4 times).
Please ask an authorized SUZUKI
dealer or a qualified workshop for the
customization.
Hazard Warning Switch
78RB02058
You can use the hazard warning switch to
warn the other drivers of possible risk of
traffic hazard when you park your vehicle
in case of emergency.
• Push the hazard warning switch to acti-
vate the hazard warning lights. The turn
signal lights and the turn signal indica-
tors on the instrument cluster will flash
simultaneously.
• Push the switch again to turn off the haz-
ard warning switch.
• The instrument panel in the above figure
is a typical example; the actual equip-
ment depends on the vehicle type.
NOTICE
If you use the hazard warning switch
for many hours with the engine
stopped, the lead-acid battery may
run out.
Do not use the hazard warning switch
for many hours with the engine
stopped.
To Next Page
Loading...
