1-6
FOR SAFE DRIVING
78RB1-01E
Rear
78RB02010
To raise the rear head restraint, pull
upward the head restraint until it clicks. To
lower the head restraint, push down the
head restraint while holding in the lock
lever. If a head restraint must be removed
(for cleaning, replacement, etc.), push in
the lock lever and pull the head restraint all
the way out.
When installing a child restraint system,
adjust the height of the head restraint or
remove it for fitting the child restraint, as
necessary.
Folding rear seats
The rear seats of your vehicle can be
folded forward to provide additional cargo
space.
To fold the rear seats forward:
1) Lower the head restraint (if equipped)
fully.
78RB02011
2) Hook the webbing of the outboard lap-
shoulder belts in the belt hangers.
78RB02012
3) For the split seat, pull the release strap
on the top of each split seat, and fold
the seatbacks forward.
For the bench seat, pull the both
release straps on the top of the bench
seat together, and fold the seatback for-
ward.
CAUTION
Remove objects from the rear seats
before folding the rear seats. There
may be a case that the rear seat belt
reminder (if equipped) will not be
activated, if objects are remained on
the rear seats.
NOTICE
• Make sure the belt webbing is not
twisted.
• When you move a seatback, make
sure the belt webbing is hooked in
the seat belt hangers so the seat
belts are not caught by the seat-
back, seat hinge, or seat latch. This
helps prevent damage to the belt
system.
To Next Page
Loading...
Need help?
General
