15
After confirming that the electrolyte has entered the
battery completely, remove the electrolyte containers
from the battery.
Wait for around 20 minutes.
Insert the caps into the filler holes, pressing in firmly so
that the top of the each caps does not protrude above
the upper surface of the battery’s top cover.
A: Caps
Charge the battery with a battery charger.
After charging the battery, install the battery in the
vehicle as follows.
NOTE:
• Use only the specified battery electrolyte.
• Once the sealing cap has been installed in the
battery, do not remove the sealing cap.
NOTE:
• For charging the battery, make sure to use the
charger specially designed for MF battery. Other-
wise, the battery may be overcharged resulting in
shortened service life.
• Do not remove the cap during charging.
• Position the battery with the cap facing upward
during charging.
NOTICE
Connecting the battery lead wires with the igni-
tion switch ON can damage the motorcycle.
Turn off the ignition switch before connecting
or disconnecting the battery lead wires.
Observe the battery lead wire polarity before
connecting the lead wires to the battery termi-
nal.
NOTICE
Reversing the battery lead wires can damage
the charging system and the battery.
Always attach the red lead to the + positive ter-
minal and the black (or black with white tracer)
lead to the - negative terminal.
NOTE:
The terminal bolts and nuts are attached to the bat-
tery.
To Next Page
Loading...
