22
ENGINE OIL
Check the engine oil level as follows.
1. Place the vehicle on level ground.
2. Start the engine and allow it to run for three minutes
at idling speed.
3. Stop the engine and wait three minutes.
4. Remove the oil filler plug.
The engine oil dipstick comes out together with the
oil filler plug.
Wipe the oil from the dipstick with a clean rag.
5. Reinsert the dipstick until the threads touch the filler
neck, but do not screw the plug in.
6. Draw out the dipstick and check the oil level.
7. If the level is below the “L” (Low) line, add fresh oil
from the filler hole.
If the level is above the “F” (Full) line, drain oil from
the drain hole.
8. Reinstall the drain plug and engine oil filler plug.
Tighten them securely.
9. Reinstall the footrest guard lid.
A: Engine oil filler plug
B: Engine oil dipstick
NOTE:
This vehicle is shipped from factory with the engine
filled with engine oil.
NOTICE
Operating the engine with too little or too much
oil can damage the engine.
Place the ATV on level ground. Check the oil
level with the engine oil dipstick before each
use of the vehicle. Be sure the engine oil level
is always above the “L” (low) line and not
higher than the “F” (full) line.
To Next Page
Loading...
