00-1 Precautions:
Precauti ons
Precautions
Precautions
Precautions for EPS (LT-A750XP/ZK9)
B931G30000004
EPS Wiring
• The EPS parts are connected to various lead wires.
The coupler and lead wire connections, as well as the
lead wire and wire harness routings must be done
correctly. Make sure that the proper clamps are used
and positioned correctly.
NOTE
If all of the connections are not properly
connected, the EPS may not operate
correctly. For connector and coupler
precautions. Refer to “Precautions for
Electrical Circuit Service in related manual”.
EPS Control Unit / EPS Body Assembly
• Never allow dust or water to contact the EPS control
unit and EPS body assembly.
• Since each component is a high-precision part, great
care should be taken not to apply any service impacts
during removal and installation.
• The EPS control unit and EPS body assembly cannot
be disassembled. Replace the whole unit with a new
one.
I931H1000004-01
I931H1000003-02
I931H1000005-01
To Next Page
Loading...
