3-76
OPERATING YOUR VEHICLE
52RM0-01E
• When the dual sensor is temporarily
stopped or malfunctioning
Situations where the system may not
activate properly
Under the following situations, the system
may not activate.
• Right after lane changing
If the dual sensor cannot detect partition
lines except for above situations, the sys-
tem may also not activate. Refer to “Situa-
tions where the dual sensor may not
activate properly” in this section for details.
High beam assist
After the auto high beam switch operation,
head light is turned ON with the lighting
control lever on “Auto” position when the
ambient becomes dark, the system is acti-
vated. When the high beam assist is acti-
vated, auto high beam indicator (green)
comes on.
Under the any of following situations, the
low beam turns on.
• When vehicle speed is approximately 35
km/h (21.7 mph) or under
• When the front of the vehicle is bright
• When the vehicle in front of you turned
on the lights
• There are many street lamps in front of
you
Under the all of the following conditions
are met, the high beams (main beams)
turns on.
• When vehicle speed is approximately 40
km/h (24.9 mph) or over
• When the front of the vehicle is dark
• When the vehicle in front of you is driv-
ing without lights
• There is few street lamps in front of you
NOTE:
• Light vehicle such as a bicycle might not
detect.
• When the sudden acceleration, high
beam assist might not operate for a few
seconds, even if vehicle speed exceeds
40km/h (24.9 mph).
How to use High beam assist
52R40460
When the engine switch is pressed to
change the ignition mode to ON, switch the
lighting control lever to “AUTO” position
and then push this lever forward. High
beam assist indicator light comes on in
green.
To cancel the function, pull the lever
toward you.
52RM20740
WARNING
• High beam assist has limits and
may not function properly depend-
ing on the surrounding environ-
ment.
Always drive in a safe manner,
switch manually to the low beams
and high beams (main beams), if
necessary.
• Switching of the low beams and
high beams (main beams) it might
not match the feeling of the driver.
To Next Page
Loading...
Need help?
General
