EasyManuals Logo

Suzuki Super Swift User Manual

Suzuki Super Swift
480 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #248 background imageLoading...
Page #248 background image
3-77
OPERATING YOUR VEHICLE
52RM0-01E
Situations where the system does not
activate
When the high beam assist indicator
light (orange) comes on by the temporar-
ily stop or malfunction of system.
NOTE:
When the function of the dual sensor brake
support is temporarily stopped, high beam
assist will be temporarily stopped. Refer to
“Temporary stop or failure of the dual sen-
sor” in this section for details.
When high beam assist indicator light
(orange) is the initial lighting immediately
after the engine switch is pressed to
change the ignition mode to ON.
Under the following situations, high
beam may not automatically switched
to low beam.
When you pass by an oncoming vehicle
on a curvy road where the visibility is
poor
When another vehicle crosses in front of
you
When the vehicle in front of you
glimpses due to continuous curves,
medial strip or street trees
When the vehicle in front of you
approaches towards you from the far
lane
When the vehicle in front of you is driv-
ing without lights
When switched to low beam by passing
each other with the oncoming vehicle on
the curve, until emerge from the curve it
may not be switched to the high beams
(main beams).
For the following cause, there is case
where the switching timing of the high
beam and low beam is varied.
When the lights of the vehicle in front of
you is dark
When only one side of the lights of the
vehicle in front of you is turned on
The directions and movements of the
vehicle in front of you
When the vehicle in front of you is a
motorcycle
When driving on the following roads
On sharp curves or extremely rough
surfaces
On a steep slope
When your vehicle is weighed down by
heavy items in the luggage compartment
or rear seat
Under the following situations, the
brightness of the surrounding area can
not be detected accurately, and there is
a case where the high beam is a nui-
sance to pedestrians or the vehicle
ahead, or low beam will remain to con-
tinue.
In these cases, change high beam or
low beam manually.
When lights are similar to headlights or
taillights are around
When the vehicle in front of you is driv-
ing without lights
When the headlights of oncoming vehi-
cle are covered in dirt or discolored
When the optical axis of the headlight of
oncoming vehicle is deviated
When the brightness is changed
extremely and continuously
When driving on an undulated or bumpy
road
When driving on the road with a lot of
curves
When there are things that strongly
reflect light, such as road signs or mir-
rors in front of the vehicle
When the rear part of the preceding
vehicle strongly reflects light, such as
containers

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Suzuki Super Swift and is the answer not in the manual?

Suzuki Super Swift Specifications

General IconGeneral
BrandSuzuki
ModelSuper Swift
CategoryAutomobile
LanguageEnglish

Related product manuals