3.Press “ ” button once more,”I/W” lights on,show “2”means
“Tuesday”.Pls noted that the operate with open time HOUR/MINUTE and
close time HOUR/MINUTE are all same as before Monday.
4.From 1-7(1=Monday,2=Tuesday...7=Sunday ect.) are all set
finised,press “ ” button on remote control 7
th
times to set from Monday
to Sunday’s temperature and press“ two buttons,select the
temperature which you need,the temperature range from 10℃ to 49℃.
PS:In Week timer function,when you set today’s temperature,the
thermostat function will start,the rules same as 4) THERMOSTAT
INSTRUCTIONS,pls noted.
You can set different open time ,closed time and temperature within
whole week.
6)Window Open Function
1.Open the appliance as working conditions,(fan,warm,hot are all ok).This
function only through by Remote control.
2.Press “ ” button, the “AUTO” light is on.The appliance is working as
smart saving energy models.(In this function,the appliance is check and
record environment temperature in immediately.It will stop working,when
the appliance check the environment are drop ≧3 ℃.The user should
restart the appliance with “ON/OFF” button)
3..Press “ ” button again, the “AUTO” light is off.Window Open
Function is closed.
7)Delay Function
1. This function can be use should be fit two points :
1. the appliance is in the standby state.
2. before the appliance working.
This function only through by Remote control.
2.Press “ ” button light on LED display ,then press “ ” button one
time, the “Delay” light and ”I/W” light are on.press “ two buttons
set the Hours from 01--24(01=1 o’clock,24=24 o’clock...00=Closed ect.)
---------------------------------------------------------This is open time
3.Press “ ” button again, the “Delay” light and ”II/H” light are on.
Press “ two buttons set the Hours from 01--24(01=1
o’clock,24=24 o’clock...00=Closed ect.)
---------------------------------------------------------This is close time
PS:Press “ ” button,screen shows number will twinkle 5 seconds,you
should operate in time ,otherwise appliance will get back to standby.
(This function is one-time and must be reset after the power is cut off.)
8)Child-Lock Function
1. This function only through by Remote control.When appliance are
plug in,this function can be used in any models.
2. Press “ ” button one time, all lights and LED display are
closed ,only “Power” light on.In this condition, both control panel and
remote control are fault use.
3. Press “ ” button again, all lights are on and both control panel and
remote control are use to succeed.
CONTROL PANEL VIEW:
REMOTE CONTROL VIEW:
To Next Page
Loading...
