How to troubleshoot a Svan Washer that won't start?
If your Svan Washer doesn't start, first ensure it's properly plugged in. Check the fuses and the mains power supply. Make sure you've pressed the Start/Pause button and that the program dial isn't in the 'stop' position. Finally, confirm that the machine door is completely closed.
Why is my Svan Washer not cleaning clothes properly?
If you're experiencing unsatisfactory washing results with your Svan Washer, first ensure you've selected the most appropriate program for the level of dirtiness of your laundry, using the information in the program tables. Also, make sure you're using the correct amount of detergent as instructed on the packaging and that you have not exceeded the maximum laundry capacity for the selected program.
Why is the spin cycle delayed on my Svan Washer?
If the spin cycle in your Svan Washer doesn't start or is delayed, it might be because the Unbalanced load control system has been activated. This system will attempt to spread your laundry evenly. Once the laundry is spread, the spinning cycle will begin. For future washes, load the drum evenly.
Why is my Svan Washer not taking in water?
If your Svan Washer isn't taking in water, start by checking if the water tap is turned on. Then, inspect the water inlet hose to ensure it's not twisted or clogged. Also, clean the water inlet hose filters and the inlet filters themselves. Finally, ensure that the machine door is completely closed.
How to stop my Svan Washer from vibrating?
If your Svan Washer is vibrating, make sure the feet have been adjusted properly and that the transit bolts used for transportation have been removed. Avoid setting up your washing machine on a hard surface. Also, ensure the drum isn't overloaded and that the laundry is spread evenly. Note that a small load in the drum will not prevent the operation of your machine.
What to do if there is excessive foam in the Svan Washer detergent drawer?
To address excessive foam in the detergent drawer of your Svan Washer, press the Start/Pause button. Dilute one tablespoon of softener into 1/2 litre of water and pour into the detergent drawer to stop the foam. Press the Start/Pause button again after 5-10 minutes. Also, ensure you're only using detergents specifically produced for automatic Washing Machines.
What to do if my Svan Washer does not discharge water?
If your Svan Washer isn't discharging water, check the drain hose for clogs or twists and clean or untwist it as needed. Also, clean the pump filter. Ensure that your laundry isn't too tightly packed in the drum; spread it evenly.
What causes unsatisfactory washing results in my Svan Washer?
If you're experiencing unsatisfactory washing results with your Svan Washer, and you have hard water, increase the amount of detergent following the manufacturer’s instructions. Also, make sure your laundry is spread out in the drum.
Why does my Svan Washer discharge water immediately after loading?
If your Svan Washer discharges water as soon as it's loaded, check that the drain hose is at a suitable height.
How to remove detergent residue from laundry after washing in my Svan Washer?
If your laundry has detergent residue after washing in your Svan Washer, it may be due to non-dissolving particles in some detergents appearing as white spots. Perform an extra rinse or clean your laundry with a brush after it dries.
To Next Page
General
