INSTALLATIONS
INSTALLING EARTHING INSTRUCTIONS
This microwave oven is designed to be used in a fully
earthed condition.
It is imperative, therefore, to make sure it is properly
earthed before servicing
WARNING-
THIS APPLIANCE
MUST BE EARTHED
IMPORTANT
As the colors of the wires in the mains lead of this
appliance may not correspond with the colored
markings identifying the terminals in your plug,
proceed as follows.
The wire which is colored green-and-yellow must be
connected to the terminal in the plug which is marked
with the letter E or by the earth symbol ( ) or
colored green or green-and-yellow .
The wire which is colored blue must be connected to
the terminal in the plug which is marked with the letter
N or colored black .
The wire which is colored brown must be connected
to the terminal in the plug which is marked with the
letter L or colored red.
BEFORE YOU BEGIN, READ THE FOLLOWING INSTRUCTIONS COMPLETELY AND CAREFULLY.
The wires in this mains lead are colored in
accordance with the following code:
Green-and-yellow: Earth
Blue: Neutral
Brown: Live
2
1. Empty the microwave oven and clean inside it with
a soft, damp cloth. Check for damage such as
misaligned door, damage around the door or dents
inside the cavity or on the exterior.
2. This oven is intended for built-in use only. it's not
3. The appliance is fitted with a plug and must only
4. The mains voltage must correspond to be voltage
5. The socket must be installed and connecting cable
6. Adaters, multi-way strips and extension leads must
intended for counter-top use or for use inside a
cupboard.
be connected to a properly installed earthed socket.
specified on the rating plate.
must only be replaced by a qualified electrician. If
not be used. Overloading can result ain a risk of fire.
the plug is no longer to accessible following insta-
present on the installation side with a contact gap
llation, an all-pole disconnecting device must be
of at least 3mm.
600
560
+8
(45)
+3
min
500
X
To Next Page
Loading...
