The refrigerator should be located in a completely flat surface , Leave 5~10 cm
between each side of the appliance and the wall, and leave 30 cm between the top
of the appliance and the ceiling.
Choose a location which is not exposed to sunlight ,
high temperature or humid , as humidity maycause stain.
Pulled out the bottom panel before installation.
The appliance can be adjusted by rolling its two legs in
front the bottom when it is unstable. Rolling in clockwise
can rise up the machine.
The location should be firm and flat. An un-securely
position may cause noise and libration:
(a)The noise may be increased if the floor is not firm.
(b) Put a sheet under the appliance for solving the heat
emission if you need to locate it onto a carpet.
Make sure the adjustable legs are clung to the floor,
and set the appliance slope backward slightly for keeping the doors closed tightly.
PLACEMENT OF FOOD
INSTALLATION INSTRUCTIONS
OPERATION INSTRUCTIONS
1.
2.
3.
4.
5.
6.
There should always be some space between items inside for air circulation.
Food should be
dry or with odour.
kept in sealed package to avoid becoming
Hot food should be cooled down before placing into the
appliance. Otherwise, interior temperature and electronic
consumption will increase.
Reduce the frequency of door opening can efficiently low
down the electronic consumption.
Do not use any electronic equipment inside the appliance.
Warning
1.
2.
3.
4.
4
can not be stored for more than7 days.
3. Meat and seafood need to be packed in different containers and stored for
not more than 3 days.
4. Raw food and cooked food need to stored in different containers. In order
to prevent bacterial contamination, raw vegetables and fruits should not
be exposed to raw meat or fish. Vegetables and fruits should be wrapped
by film and stored in the crisper.
2. The common temperature of the chilling room is from -1 to 4°C, and meat
INSTRUCTION FOR USAGE
Unpack , repack and carry
Please memorize the position of each accessory of the appliance
when unpack it, repack the product and check it carefully before
transportation.
Do not lift or pull the door or the door handle during transportation.
When moving, the appliance can not be sloped over 45 degrees
(the angle to the vertical direction). Please avoid strong vibration
and hit.
PACKING AND MOVING
1.
2.
3.
The appliance should be maintained and cleaned frequently. For your safety,do
please pull the plug out of the socket before the cleaning.
Interior maintenance
Clean the interior of the appliance with clean water or neutral abluent.Scour it with
clean water and wipe it with a piece of dry cloth.
Maintenance of door gasket
It is easy to damage if the door gaskets are polluted by the stain like oil, sauce and
etc., so it is better to clean them carefully.
Outer maintenance
Wipe the dusty with a piece of dry cloth ,clean it with neutral abluentif necessary.
MAINTENANCE
1.
2.
3.
The displacement of interior light Uninstall the cover and replace the light with a
screwing light (E14 , 220V/10W)，Consult the following pictures：
4.
1) Move the lampshade 3~5mm according
to arrow point direction.
2) Take out the lamp shade.
3) Rotate and take out the bullb in counterclockwise direction.
5
The temperature of refrigerator can be controlled manually by
the knob. However, the number shown on the knob does not
directly represent the temperature. Instead, the larger the
number is, the lower the interior temperature will be. 0 stands for
off. 7 stands for the coldest temperature level. The tempreture in
every apartment will be at the lowest degree under this level, and
it probably make it below 0°C in the fridge department, so please
choose carefully before you use.Turn the knob to level 4 when it
is normal, turn it to the level 4-6 if a lower interior temperature is
required; contrarily, lower to
4-1, when a higher one is needed.
To Next Page
Loading...
