Sven PS-235 - Connection and Operation Modes; Speaker System Battery Charging; Bluetooth Mode; Radio Mode

ENG
4
Portable Speaker System
withBluetooth and FM-radio
CONNECTION AND OPERATION
Attention! The built-in battery must be charged completely prior to the application.
Speaker system battery charging
• Open the protective cover and connect the speaker to the PC's USB port or USB charger using
the USB Type-C cable (included). When charging, indicator i will light red.
• The battery is used in the speaker system as an integral part ofthe device, therefore do not try
to extract or replace it, because this can result in the warranty cancellation or the device damage.
OPERATION MODES
Bluetooth mode
• Wireless data transfer via the Bluetooth protocol enables to connect speaker system to compat-
ible devises. Maximum radius of action of data transfer is 10 m. Such obstacles as walls orother
electronic devices can interfere with the signal transfer.
• Turn on the speaker, the device will automatically enter Bluetooth source search mode, the
indicator will ash blue.
• It is necessary to select the search mode of devices with Bluetooth on a signal source (tele-
phone, notebook, smartphone, etc.). “SVEN PS-235” message will be displayed on the screen
which is to be connected to*.
• When connection is successful, there will be a short beep**.
Radio mode
• To improve radio reception, connect USB to USB type-C cable (included) to the input k
orsignal cable 3.5 mm mini-jack to 3.5 mm mini-jack (included) to input l.
Turn on the speaker system — press button c several times until, the radio mode will turn on.
Long-term pressing button d activates auto search mode. After scanning completion, therst
scanned radio station will start to operate automatically. With buttons a and b (long pressing)
select a desired radio station.
Player mode
Attention! The le system of a USB ash carrier is FAT32. Maximum volume is 32 GB.
• Open the protective cover and install the USB ash into slot 10. Turn on the speaker, playback
will start automatically. Button d switches Play/Pause modes (short press). Using buttons a
and b (long press) you can switch between tracks.
* You might have to enter “0000” code to connect some models of devices via Bluetooth.
** If the item has been already registered in the device list of a source, then the second search
mode activation is not obligatory. Choose the item name “SVEN PS-235” and the “connect” com-
mand onthe source .