Sven PS-55 - Page 4

ENG
4
Portable Speaker System
withBluetooth and FM-radio
•The battery is used in the speaker system as an integral part of the device, therefore
do not try to extract or replace it, because this can result in the warranty cancellation
or the device damage.
OPERATION MODES
Bluetooth mode
•Wireless data transfer via the Bluetooth protocol enables to connect speaker system
to compatible devises. Maximum radius of action of data transfer is 10 m. Such obstacles
as walls or other electronic devices can interfere with the signal transfer.
•Turn on the speaker in Bluetooth mode.
•It is necessary to select the search mode of devices with Bluetooth on a signal source (tele-
phone, notebook, smartphone, etc.). «SVEN PS-55» message will be displayed onthescreen
which is to be connected to*.
•When connection is successful, there will be a short beep and the indication ofthesearch
mode on speaker system is over**.
Radio mode
To improve the quality of radio reception, connect the microUSB ― USB cable (included)
to the microUSB input or the mini-jack signal cable to the mini-jack (included) to the AUX
f input.
•Turn on the speaker system ― press button c several times until, the radio mode will
turn on. Double pressing button a activates auto search mode. After scanning comple-
tion, the rst scanned radio station will start to operate automatically. With buttons b
and e (long pressing) select a desired radio station.
Player mode
Attention! The le system of a micro SD carrier is FAT32. Maximum volume is 32 GB. Itisnot
recommended to use the micro SD Ultra Speed.
•The system will enter the Player mode automatically when a carrier (USB ash or SD
card) is connected to corresponding ports. Use button a to switch between Play/Pause
modes. You can control tracks by using buttons b (previous track) and e (next track)
(long pressing).
The use in the wired mode (AUX)
•Connect the 3.5 mm mini-jack cable to the 3.5 mm mini-jack (included) to the AUX f
input and the 3.5 mm jack to the signal source.
•Turn on the speaker in AUX mode ― press the button c several times until the speaker
goes into AUX mode.
* You might have to enter «0000» code to connect some models of devices via Bluetooth.
** If the item has been already registered in the device list of a source, then the second
search mode activation is not obligatory. Choose the item name «SVEN PS-55» andthe«con-
nect» command on the source.
Connecting an additional speaker
For model «SVEN PS-55» you can connect an additional speaker (Bluetooth mode only):
Attention! Before connecting an additional speaker, disconnect both speakers fromthesig-
nal source.