Sven PS-650 - Connection and Operation; Speaker System Battery Charging; Operation Modes

ENG
5
User Manual
PS-600, PS-650, PS-655
f , CH-: previous track (in Player and Bluetooth mode);
Rewind track in Player mode (long pressing);
Previous station (in Radio mode)
g , CH+: next track (in Player and Bluetooth mode);
Rewind track in Player mode (long pressing);
Next station (in Radio mode)
h , AUTO SCAN: Play/Pause button (in Player and Bluetooth
mode);
Start/Stop auto scan (long pressing in Radio mode);
Mute (short pressing in Radio and LINE IN mode)
i FM-/+: frequency changeа (in Radio mode)
j 0-9: numeric pad for entering track number (in Player mode)
or number track/station in Radio mode
Fig. 2.
•The battery is used in the speaker system as an integral part of the device, therefore do not
try to extract or replace it, because this can result in the warranty cancellation or the device
damage.
OPERATION MODES
Bluetooth mode
• Wireless data transfer via the Bluetooth protocol enables to connect speaker system to
compatible devises. Maximum radius of action of data transfer is 10 m. Such obstacles as walls
or other electronic devices can interfere with the signal transfer.
• Turn on the speaker system Bluetooth mode – press button МODE j several times until
display shows «bt» inscription.
• It is necessary to select the search mode of devices with Bluetooth on a signal source
(telephone, notebook, smartphone, etc.). «SVEN PS-600/650/655» massage will be displayed on
the screen which is to be connected to*.
• When connection is successful, there will be a short beep and the indication of the search
mode on speaker system is over**.
* You might have to enter «0000» code to connect some models of devices via Bluetooth.
** If the item has been already registered in the device list of a source, then the second search
mode activation is not obligatory. Choose the item name «SVEN PS-600/650/655» and the
«connect» command on the source.
CONNECTION AND OPERATION
Attention! The built-in battery must be charged completely prior
to the application.
Speaker system battery charging
• Connect speaker system to a USB port of PC or USB charger
using USB type C to USB cable (included). During battery
charging the indicator h is red. Indicator h goes out when
the battery is charged.