WWW.SWAGOFFROAD.COM
“DOING ORDINARY EXTRAORDINARY”
7) Trigger Control.
We recommend using an 8” Velcro strap or a 2.5” spring clamp to hold down the
trigger on the saw. These options can easily be removed when the saw is not
mounted in the SWAG Portaband table.
8) Hex Key Retention.
We have found a great place to store the 5/32” hex key, place it inside the power
chord rubber boot show below. Regardless of how you store this key it will be needed
to remove your saw from the table. The same hex key can be used to adjust the bolt
on miter gauge rails if they come loose or have rotated during shipping.
To Previous Page
Loading...