SWAG V4.0 User Manual

WWW.SWAGOFFROAD.COM
“DOING ORDINARY EXTRAORDINARY”
SWAG Portaband Table V4.0 Installation
Instructions
1) Install bolt on side legs:
Attach the bolt on side legs using the supplied 5/16” bolts
and nuts.
2) Hardware Kit Assembly:
Using the supplied 5/32” hex key and a ½” wrench, install the 5/16” jam nut so it is
flush with the bottom of the 5/16” set screw.
3)Set Screw Installation:
Install the 7/8” long set screw from the bottom of the table so the top of the fastener
protrudes through the top of the table ~3/16”.

SWAG V4.0 Specifications

General

Brand	SWAG
Model	V4.0
Category	Tool Storage
Language	English

Summary

Install Bolt on Side Legs

Hardware Kit Assembly

Set Screw Installation

Blade Guard Operation

Saw Installation into Table

Blade Alignment Procedure

Trigger Control Method

Hex Key Storage and Use