Need help?Do you have a question about the Swan Analytical Instruments AMI Silitrace and is the answer not in the manual?
Symbols and their meanings for safety-related notices.
Essential steps and requirements for proper instrument installation.
Procedures and precautions for making electrical connections.
Step-by-step guide for initial instrument commissioning.
A schedule outlining routine maintenance tasks and intervals.
Instructions for replenishing or changing reagent containers.
Steps to perform instrument calibration for accuracy.
A comprehensive list of error codes and their corrective actions.
Symbols and their meanings for safety-related notices.
Essential steps and requirements for proper instrument installation.
Procedures and precautions for making electrical connections.
Step-by-step guide for initial instrument commissioning.
A schedule outlining routine maintenance tasks and intervals.
Instructions for replenishing or changing reagent containers.
Steps to perform instrument calibration for accuracy.
A comprehensive list of error codes and their corrective actions.
General| Parameter | Silica |
|---|---|
| Response Time | Typically 5-15 minutes depending on concentration |
| Sample temperature | 5 to 45 °C |
| Protection degree | IP54 |
| Measurement Principle | Colorimetric measurement using the molybdenum blue method |
| Detection Limit | 1 ppb |
| Repeatability | ±1% of measured value or ±1 ppb, whichever is greater |
| Sample Flow Rate | 0.5-2 mL/min |
| Ambient temperature | 5 to 45 °C |
| Power supply | 100 to 240 VAC, 50/60 Hz |
| Reagent Consumption | Approx. 1 L per month (depending on usage) |
| Outputs | 2 x 0/4 - 20 mA |
| Range | 0-200 µg/L, 0-2000 µg/L (optional) |
| Sample flow | 0.5-2 mL/min |
| Operating Temperature | 10 to 45 °C |
To Next Page