Swedstyle Space - Getting Started and Operation; Initial Setup Guidelines; Manual Reset Procedure

CAUTION
Ensure there are no obstructions to the movement of the furnishing. •
All cable management should be sufcient to allow manoeuvrability
of the frame through its entire working range.
Upon successful assembly ofthe desk, position the desk in itsnal •
location and level the top using the levelling foot screwson each leg.
Always ensure that no obstructions have been placed under, above or •
adjacent to the furnishing.
A clearance of 50mm surrounding the furnishing is recommended .•
Upon successful assembling of the desk, it is vital that•
the desk is reseted manually before use. See below:•
Reset procedure
Lower the frame to its lowest position by pressing the down arrow on the
hand control. Release the button. Press the button again and keep it pressed
for 10seconds.
Note!
If any of the motor cables have been disconnected while the product is connected
to power, the reset procedure must be carried out.
5. GETTING STARTED
Read the following instructions carefully. The user should be fully aware and
conversant in the operation, function and use of the desks. Each user should
be compliant with the safety regulations concerned with the operation, function
and use of the desks.